PERMANON MATT - 100ML
PERMANON MATT - 100ML, seals surfaces and protects them against contamination. Permanon Matt was specially designed to protect matte and satin adhesive films, as well as transparent PPF protection films.
This product does not change the appearance / finish of the applied adhesive film or PPF film and ensures excellent adhesion to the material that needs to be maintained and protected.
The product contains silicon and special water-based maintenance substances.
As a result of treatment with Permanon MATT, the surface becomes even smoother, and dirt is less likely to adhere, as it previously did when the surface was rough. The product does not contain alcohol as a carrier substance, nor does it contain fluorinated silanes or chemical silicone oils as solvents.
Permanon Matt is non-toxic; the silicon adheres electrostatically to surfaces, creating a protective film lasting up to 3-4 months, depending on the environment.
Main features:
- Ideal for protecting matte, satin and PPF adhesive films
- excellent water-repellent effect
- easier cleaning
- UV resistant
- non-toxic, non-flammable
- solvent-free, biodegradable
- resistant from -40°C to 300°C
- based on Pure Monomeric Silicon 14SI nanoparticles
- electrostatic bond with the surface, not chemical
- also available in the “2 in 1 - Cleaning and protection” version
Fast and thorough cleaning, simplified
Before application, thoroughly clean and degrease the surface to be protected, then apply or spray a 2% solution onto the surface. Remove excess product, rinse or dry. The intense gloss effect is enhanced when the surface is dried with a microfiber cloth. Compared to competing products, Permanon is easy to use because it cleans and protects in a single step. This gives you flawless shine and protection. In addition, subsequent maintenance/cleaning becomes more than 80% easier.
Dosage:
First application: mix PERMANON 3-5% with water, preferably distilled or softened.
To renew the shine, a 2-3% solution is sufficient.
Important note:
After mixing with water, the application solution remains stable for approximately three weeks.
