SOTT FILM REMOVER 5L

SOTT FILM REMOVER 5L, can be used for removing films from original factory automotive paints or for removal from surfaces repainted with quality materials. It can also be used on glass, various metals and other hard surfaces without damage (depending on application timing). Not recommended for application on rubber, soft plastic, tarpaulins, cellulosic paints, banners and soft quality materials.

Warning: This is a corrosive product. It may attack adjacent surfaces, such as plastic materials (unpainted), handles, protection bars, door rubbers and protection bars. It is not intended for dilution with water and alkyd resins.

Always test on a small area of each surface to see if the above product is suitable for your application. Before use, perform a test to see if 600-TRL-1000 Film Remover is suitable for your application. We are never responsible for any damage that may occur.

INSTRUCTIONS: Apply 600-TRL-1000 in large quantities with a brush directly on the film to be removed, wait a few minutes depending on the type of decal and use plastic or teflon squeegees to remove the softened mass from the surface. Repeat again if necessary. Clean the surface of any remaining adhesive and clean with a good degreaser.